IPv6 Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 30-75
Related Commands
MIB Objects
alaRipngInterfaceTable
alaRipngInterfaceStatus
ipv6 redist Loads RIPng into memory.
ipv6 rip status Enables or disables RIPng on the switch.
ipv6 rip interface recv-status Configures IPv6 RIPng interface “Receive” status. When this status
is set to "enable", packets can be received on this interface.
ipv6 rip interface send-status Configures IPv6 RIPng interface “Send” status. When this status is
set to "enable", packets can be sent on this interface.
show ipv6 rip interface Displays information for all or specified RIPng interfaces.
To Next Page
Loading...
