QoS Commands
OmniSwitch CLI Reference Guide November 2009 page 38-41
• Once the qos port servicing mode command is used on a port, this same command is required to make
any additional mode changes for that port. If the port is changed back to the default servicing mode,
however, this restriction is removed and the qos default servicing mode command is also allowed on
the port.
Examples
-> qos port 3/1 servicing mode strict-priority
-> qos port 3/3 servicing mode wrr 1 2 3 4 5 6 7 8
-> qos default servicing mode priority-wrr 0 10 0 9 0 0 2 3
-> qos port 3/4 servicing mode drr 10 11 12 13 14 15 16 17
-> qos port 3/2 servicing mode default
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaQoSPortTable
alaQoSPortServicingMode
alaQosPortQ0PriorityWeight
alaQosPortQ1PriorityWeight
alaQosPortQ2PriorityWeight
alaQosPortQ3PriorityWeight
alaQosPortQ4PriorityWeight
alaQosPortQ5PriorityWeight
alaQosPortQ6PriorityWeight
alaQosPortQ7PriorityWeight
qos apply Applies configured QoS and policy settings to the current configuration.
qos default servicing mode Configures the default servicing mode for all switch ports.
show qos queue Displays information for all QoS queues.
To Next Page
Loading...
