Alcatel-Lucent OmniSwitch 6250 - Monitoring the Stack; CLI Commands Used for Monitoring a Stack

OmniSwitch 6250 CLI Reference Guide November 2009 page 6-1
6 Session Management
Commands
Session Management commands are used to monitor and configure operator sessions including FTP,
Telnet, HTTP (WebView), console, Secure Shell, and Secure Shell FTP on the switch. (See the SNMP
Commands chapter for SNMP session commands.) Maximum number of concurrent sessions allowed:
MIB information for commands in this chapter are as follows:
Filename: AlcatelInd1SessionMgr.mib
Module: AlcatelIND1SessionMgrMIB
Filename: AlcatelIND1AAA.mib
Module: Alcatel-IND1-AAA-MIB
Filename: AlcatelIND1System.mib
Module: Alcatel-IND1ConfigMgr.mib
Filename:AlcatelIND1Ssh.mib
Module: ALCATEL-IND1-SSH-MIB
Session OS-6250
Telnet(v4 or v6) 4
FTP(v4 or v6) 4
SSH + SFTP(v4 or v6 secure
sessions)
8
HTTP 4
Total Sessions 20
SNMP 50