IP Multicast Switching Commands
page 41-72 OmniSwitch 6250 CLI Reference Guide November 2009
-> show ip multicast vlan 1
Status: Enabled
Querying: Disabled
Proxying Disabled
Spoofing: Disabled
Zapping: Disabled
Querier Forwarding: Disabled
Version: 2
Robustness: 2
Query Interval (seconds): 125
Query Response Interval (tenths of seconds): 100
Last Member Query Interval(tenths of seconds):10
Unsolicited Report Interval(seconds): 1
Router Timeout (seconds): 90
Source Timeout (seconds): 30
Output fields are described here:
output definitions
Status Whether the IP Multicast Switching and Routing is Enabled or Dis-
abled (the default status).You can enable or disable IP Multicast
Switching and Routing with the ip multicast status command, which is
described on page 41-3.
Querying The current state of IGMP querying, which can be Enabled or Dis-
abled (the default status). You can enable or disable IGMP querying
with the ip multicast querying command, which is described on page
41-27.
Proxying The current state of IGMP proxying on the system, which can be
Enabled or Disabled (the default status). You can enable or disable
IGMP spoofing with the ip multicast proxying command, which is
described on page 41-35.
Spoofing The current state of IGMP spoofing on the system, which can be
Enabled or Disabled (the default status). You can enable or disable
IGMP spoofing with the ip multicast spoofing command, which is
described on page 41-31.
Zapping The current state of IGMP zapping on the system, which can be
Enabled or Disabled (the default status). You can enable or disable
IGMP zapping with the ip multicast zapping command, which is
described on page 41-33.
Querier Forwarding The current state of IGMP querier forwarding on the system, which can
be Enabled or Disabled (the default status). You can enable or disable
IGMP Querier forwarding with the ip multicast querier-forwarding
command, which is described on page 41-5.
Version Displays the default IGMP version, which can be 1, 2 or 3. Use the ip
multicast version command to modify this parameter.
Robustness Displays the IGMP robustness value, ranging from 1 to 7. (The default
value is 2). Use the ip multicast robustness command to modify this
parameter.
To Next Page
Loading...
