IP Multicast Switching Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 41-73
Release History
Release 6.6.1; command was introduced.
Query Interval (seconds) Displays the time (in seconds) between IGMP queries. (The default
value is 125 seconds). You can modify this parameter with the
ip multicast query-interval command, which is described on page
41-15.
Query Response Interval
(tenths of seconds)
Displays the time (in tenths of seconds) taken to reply to an IGMP
query message. (The default value is 100 tenths-of-seconds). You can
modify this parameter with the ip multicast query-response-interval
command, which is described on page 41-19.
Last Member Query Interval
(tenths of seconds)
Displays the time (in tenths of seconds) taken to reply to an IGMP
query message sent in response to a leave group message. (The default
value is 10 tenths-of-seconds.) You can modify this parameter with the
ip multicast last-member-query-interval command, which is
described on page 41-17.
Unsolicited Report Interval
(seconds)
Displays the time period (in seconds) to proxy any changed IGMP
membership state. (The default value is 1 second). You can modify this
parameter with the ip multicast unsolicited-report-interval com-
mand, which is described on page 41-21.
Router Timeout (seconds) Displays the IGMP router timeout in seconds. (The default value is 90
seconds.) You can modify this parameter with the
ip multicast router-timeout command, which is described on page
41-23.
Source Timeout (seconds) Displays the IGMP source timeout in seconds. (The default value is 30
seconds.) You can modify this parameter with the
ip multicast source-timeout command, which is described on page
41-25.
output definitions
To Next Page
Loading...
