AAA Commands
page 43-8 OmniSwitch 6250 CLI Reference Guide November 2009
Defaults
Defaults for optional parameters are as follows:
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• The dn_name must be different from the search_base name.
• Use the no form of the command to remove an LDAP server from the configuration. Only one server
may be removed at a time.
• The port number configured on the switch must match the port number configured for the server.
Examples
-> aaa ldap-server topanga5 host 10.10.3.4 dn cn=manager password tpub base c=us
retransmit 4
-> no aaa ldap-server topanga5
Release History
Release 6.6.1; command was introduced.
Related Commands
parameter default
port 389 (SSL disabled)
636 (SSL enabled)
retries 3
seconds 2
ssl | no ssl no ssl
show aaa server Displays information about AAA servers.
aaa authentication Specifies the AAA servers to be used for authenticated switch
access.
aaa accounting session Specifies the accounting servers to be used for Authenticated
Switch Access.
To Next Page
Loading...
