File Management Commands
page 7-16 OmniSwitch 6250 CLI Reference Guide November 2009
rm
Permanently deletes an existing file. This command can also delete a directory if the -r keyword is used.
rm [-r] [path/]filename
Syntax Definitions
-r Syntax that recursively removes directories, as well as any associated
subdirectories and files. Be sure to include a space between the syntax
rm and -r (i.e., rm -r).
path The path (i.e., location) containing the file being removed. If no path is
specified, the command assumes the current directory.
filename The name of the existing file being deleted. Up to thirty-two (32) char-
acters may be used (e.g., test_config_file).
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Be sure to separate path directories and file names with a slash (/). Refer to the examples below.
• Use care when deleting files. Depending on your switch and network configurations, specific configu-
ration and image files must be present for your system to work properly.
• This command can also be used on the secondary CMM.
Examples
-> rm test_config_file
-> rm flash/test_config_file
Release History
Release 6.6.1; command was introduced.
Related Commands
delete Deletes an existing file.
To Next Page
Loading...
