Distributed Spanning Tree Commands
page 16-24 OmniSwitch 6250 CLI Reference Guide November 2009
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
vStpInsTable
vStpInsNumber
vStpInsPriority
vStpInsBridgeAddress
bridge mode Selects the Spanning Tree operating mode (flat or 1x1) for the switch.
bridge priority Implicit command for changing the Spanning Tree priority for the flat
mode CIST instance or a 1x1 mode VLAN instance.
bridge msti priority Explicit command for changing the Spanning Tree priority for an MSTI
when the switch is operating in either the flat or 1x1 mode.
bridge 1x1 protocol Explicit command for changing the Spanning Tree priority for a VLAN
instance when the switch is operating in either the flat or 1x1 mode.
To Next Page
Loading...
