Distributed Spanning Tree Commands
page 16-56 OmniSwitch 6250 CLI Reference Guide November 2009
Examples
-> bridge mode flat
-> bridge cist 4/1 enable
-> bridge cist 16 enable
-> bridge mode 1x1
-> bridge cist 5/10 enable
-> bridge cist 22 enable
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
vStpInsPortTable
vStpInsPortNumber
vStpInsPortEnable
bridge mode Selects the Spanning Tree operating mode (flat or 1x1) for the switch.
bridge slot/port Implicit command for configuring the Spanning Tree status on a port for
the flat mode CIST instance or for a 1x1 mode VLAN instance.
bridge 1x1 slot/port Explicit command for configuring the Spanning Tree status on a port or
an aggregate of ports for a VLAN instance when the switch is operating
in either the 1x1 or flat mode.
vlan stp Enables or disables the Spanning Tree instance for a VLAN.
bridge bpdu-switching Enables or disables BPDU switching for the specified VLAN.
To Next Page
Loading...
