Distributed Spanning Tree Commands
page 16-66 OmniSwitch 6250 CLI Reference Guide November 2009
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
vStpInsPortTable
vStpInsPortNumber
vStpInsPortPriority
bridge mode Selects the Spanning Tree operating mode (flat or 1x1) for the switch.
bridge slot/port priority Implicit command for configuring the Spanning Tree priority value for a
port or an aggregate of ports that applies to the specified CIST or VLAN
instance.
bridge slot/port path cost Explicit command for configuring the Spanning Tree priority value for a
port or an aggregate of ports for the CIST instance when the switch is
operating in either the 1x1 or flat mode.
bridge msti slot/port priority Explicit command for configuring the Spanning Tree priority value for a
port or an aggregate of ports for an MSTI when the switch is operating
in either the 1x1 or flat mode.
To Next Page
Loading...
