Distributed Spanning Tree Commands
page 16-84 OmniSwitch 6250 CLI Reference Guide November 2009
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
vStpInsPortTable
vStpInsPortNumber
vStpInsPortManualMode
bridge mode Selects the Spanning Tree operating mode (flat or 1x1) for the switch.
bridge slot/port mode Implicit command for configuring the Spanning Tree mode for a port or
an aggregate of ports for the CIST instance or a VLAN instance.
bridge 1x1 slot/port mode Explicit command for configuring the Spanning Tree mode for a port or
an aggregate of ports for the specified VLAN instance when the switch
is operating in either the 1x1 or flat Spanning Tree mode.
To Next Page
Loading...
