Distributed Spanning Tree Commands
page 16-98 OmniSwitch 6250 CLI Reference Guide November 2009
Examples
-> bridge mode flat
-> bridge cist 15 auto-edge on
-> bridge cist 8/23 auto-edge disable
-> bridge mode 1x1
-> bridge cist 2/2 auto-edge enable
-> bridge cist 10 auto-edge off
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
vStpInsPortTable
vStpInsPortNumber
vStpInsPortAutoEdge
bridge mode Selects the Spanning Tree operating mode (flat or 1x1) for the switch
bridge 1x1 slot/port auto-edge Configures whether or not Spanning Tree determines the operational
edge port status for a port or an aggregate of ports for the specified 1x1
mode VLAN instance.
bridge cist slot/port admin-edge Configures the administrative edge port status for a port or aggregate
of ports for the CIST instance.
bridge 1x1 slot/port admin-edge Configures the administrative edge port status for a port or an aggre-
gate of ports for a specific VLAN instance.
To Next Page
Loading...
