Distributed Spanning Tree Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 16-133
-> show spantree 1x1 7
Spanning Tree Parameters for Vlan 7
Spanning Tree Status : ON,
Protocol : IEEE STP,
mode : 1X1 (1 STP per Vlan),
Priority : 32768 (0x8000),
Bridge ID : 8000-00:d0:95:6a:f4:58,
Designated Root : 0000-00:00:00:00:00:00,
Cost to Root Bridge : 0,
Root Port : Slot 1 Interface 1,
Next Best Root Cost : 0,
Next Best Root Port : Slot 1 Interface 1,
Tx Hold Count : 6,
Topology Changes : 0,
Topology age : 00:00:00,
Current Parameters (seconds)
Max Age = 20,
Forward Delay = 15,
Hello Time = 2
Parameters system uses when attempting to become root
System Max Age = 20,
System Forward Delay = 15,
System Hello Time = 2
-> show spantree 1x1 10-15
Spanning Tree Path Cost Mode : AUTO
Vlan STP Status Protocol Priority
-----+----------+--------+--------------
10 ON RSTP 32768 (0x8000)
11 ON RSTP 32768 (0x8000)
12 ON RSTP 32768 (0x8000)
13 ON RSTP 32768 (0x8000)
14 ON RSTP 32768 (0x8000)
15 ON RSTP 32768 (0x8000)
output definitions
Spanning Tree Path Cost
Mode
The Spanning Tree path cost mode for the switch (32 BIT or AUTO)
Configured through the bridge path cost mode command.
Vlan The VLAN ID associated with the VLAN Spanning Tree instance.
Configured through the vlan commands
STP Status The Spanning Tree state for the instance (ON or OFF).
Protocol The Spanning Tree protocol applied to the VLAN instance (STP or
RSTP). Note that MSTP is not supported for a VLAN instance. Con-
figured through the bridge protocol command.
Mode The Spanning Tree operating mode for the switch (1x1 or flat). Config-
ured through the bridge mode command.
Priority The Spanning Tree bridge priority for the instance. The lower the num-
ber, the higher the priority. Configured through the bridge priority
command.
Bridge ID The bridge identifier for this Spanning Tree instance. Consists of the
bridge priority value (in hex) concatenated with the dedicated bridge
MAC address.
To Next Page
Loading...
