Distributed Spanning Tree Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 16-147
Release History
Release 6.6.1; command was introduced.
output definitions
Port The slot number for the module and the physical port number or a logi-
cal port. If the slot number is 0, then the port number refers to a link
aggregate logical port number (e.g., 0/31).
Port Pri The Spanning Tree priority for the port (0–15). The lower the number,
the higher the priority. Configured through the bridge slot/port prior-
ity command.
Adm St The Spanning Tree administrative status of the port: enabled or dis-
abled. Configured through the bridge slot/port command to enable or
disable Spanning Tree on a port.
Man. Mode The manual mode setting for the port: yes indicates that the blocking or
forwarding state of the port was manually set and the port does not par-
ticipate in the Spanning Tree Algorithm; no indicates that the Spanning
Tree Algorithm is managing the port state. Configured through the
bridge slot/port mode command.
Config Cost The configured path cost value for this port. Configured through the
bridge slot/port path cost command.
Adm Cnx The administrative connection type: PTP, NPT, or AUT. Configured
through the bridge slot/port connection command.
Adm Edg The edge port administrative status: yes indicates that the port is an
admin edge port; no indicates that the port is not an admin edge port.
Configured through the bridge slot/port connection command.
Aut Edg The edge port automatic status: yes indicates that the port is an auto-
matic edge port; no indicates that the port is not an automatic edge port.
Configured through the bridge cist slot/port auto-edge or bridge 1x1
slot/port auto-edge command.
Rstr Tcn The restricted TCN capability: yes indicates that the port supports the
restricted TCN capability; no indicates that the port does not support
the restricted TCN capability. Configured through the bridge cist slot/
port restricted-tcn or bridge 1x1 slot/port restricted-tcn command.
Rstr Role/Root Guard The restricted status of the port: Yes indicates that the port is restricted
from becoming the root; No indicates that the port is not restricted from
becoming the root. Configured through the bridge cist slot/port
restricted-role or bridge 1x1 slot/port restricted-role command.
OS8800 10G Opt.
N/A
PVST+ Cfg Stat The PVST+ status on the switch: enabled or disabled. Configured
through the bridge mode 1x1 pvst+ command to enable or disable
PVST+ mode on the switch.
PVST+ Stat Indicates whether or not the PVST+ interoperability status is enabled
(ENA) or disabled (DIS) for the port. Configured throught the bridge
mode 1x1 pvst+ command.
To Next Page
Loading...
