Distributed Spanning Tree Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 16-153
Release History
Release 6.6.1; command was introduced.
Related Commands
Man. Mode The manual mode setting for the port: yes indicates that the blocking or
forwarding state of the port was manually set and the port does not par-
ticipate in the Spanning Tree Algorithm; no indicates that the Spanning
Tree Algorithm is managing the port state. Configured through the
bridge slot/port mode command.
Config Cost The configured path cost value for this port. Configured through the
bridge msti slot/port path cost command.
Adm Cnx The administrative connection type: PTP, NPT, or AUT. Configured
through the bridge slot/port connection command.
Adm Edg The edge port administrative status: yes indicates that the port is an
admin edge port; no indicates that the port is not an admin edge port.
Configured through the bridge slot/port connection command.
Aut Edg The edge port automatic status: yes indicates that the port is an auto-
matic edge port; no indicates that the port is not an automatic edge port.
Configured through the bridge cist slot/port auto-edge or bridge 1x1
slot/port auto-edge command.
Rstr Tcn The restricted TCN capability: yes indicates that the port supports the
restricted TCN capability; no indicates that the port does not support
the restricted TCN capability. Configured through the bridge cist slot/
port restricted-tcn or bridge 1x1 slot/port restricted-tcn command.
Rstr Role The restricted role port status: yes indicates that the port is a restricted
role port; no indicates that the port is not a restricted role port. Config-
ured through the bridge cist slot/port restricted-role or bridge 1x1
slot/port restricted-role command.
OS8800 10G Opt. N/A
show spantree ports Implicit command for displaying Spanning Tree port information
for the flat mode CIST instance or a 1x1 mode VLAN instance.
show spantree cist ports Explicit command for displaying Spanning Tree port information
for a CIST instance when the switch is operating in the 1x1 or flat
Spanning Tree mode.
show spantree 1x1 ports Explicit command for displaying Spanning Tree port information
for a VLAN when the switch is operating in the 1x1 or flat Span-
ning Tree mode.
output definitions (continued)
To Next Page
Loading...
