VLAN Management Commands
page 22-16 OmniSwitch 6250 CLI Reference Guide November 2009
-> show vlan 10 port
port type status
+------+--------+------------+
1/1 default forwarding
1/2 qtagged forwarding
1/3 mobile forwarding
-> show vlan port 3/2
vlan type status
+------+---------+------------+
1 default forwarding
2 qtagged forwarding
5 dynamic blocking
3 qtagged blocking
-> show vlan 500 port 8/16
type :default
status :blocking
vlan admin :on
vlan oper :off
port admin :on
port oper :off
output definitions
vlan Numerical VLAN ID. Identifies the port’s VLAN assignment.
port The slot number for the module and the physical port number on that
module (e.g. 3/1 specifies port 1 on slot 3).
type The type of VPA: default (configured default VLAN assignment for
the port), qtagged (802.1Q tagged secondary VLAN assignment for the
port), mobile (dynamic secondary VLAN assignment for the port),
mirror (port is mirroring the VLAN assignment of another port), or
dynamic (VPAs that are learnt through GVRP).
status The VPA status: inactive (port is not active), forwarding (traffic is for-
warding on this VPA), blocking (traffic is not forwarding on this VPA),
or filtering (a mobile port’s VLAN is administratively off or the port’s
default VLAN status is disabled; does not apply to fixed ports).
vlan admin VLAN administrative status: on enables VLAN functions to operate;
off disables VLAN functions without deleting the VLAN. Use the vlan
command to change the VLAN administrative status.
vlan oper VLAN operational status: on (enabled) or off (disabled). The opera-
tional status remains disabled until an active port is assigned to the
VLAN. When the operational status is enabled, then VLAN properties
(e.g. router interfaces, Spanning Tree) are applied to ports and traffic
flow. A VLAN must have an enabled administrative status before it can
become operationally enabled.
To Next Page
Loading...
