Keysight x-series Instruction Manual

6 Input/Output
6.4 Data Source
Note that the Sample Rate key is grayed out if the file type you loaded contains
Sample Rate information. BIN and BINX files do not include sampling rate
information inside the file, so after recalling one of these file types, you will need to
set the Sample Rate. You should have noted the Sample Rate that was displayed on
the Sweep, Recording menu panel after you saved the file.
After the recall is performed, you will also see that the Data Source control has
switched to File. You can see this on the Data Source menu panel, and also on the
dropdown from the Measurement Bar on the far-left side of the instrument:
2107 Short Range Comms & IoT Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)