3 Short-Range Comms & IoT Mode
3.4 HRP UWB Demodulation Measurement
n Return Value
3 Pass/Fail result of Main lobe width
4 Pass/Fail result of Side Lobe Peak
5 Pass/Fail result of STS Normalized RMSE
6 Pass/Fail result of SHR Normalized RMSE
7 Pass/Fail result of Data Normalized RMSE
8 Pass/Fail result of Transmit Mask Limit
9 Pass/Fail result of PHR Normalized RMSE
10 Pass/Fail result of PSDU Normalized RMSE
*For result 8 (Pass/Fail result of Transmit Mask Limit), if the value returned is -999, it indicates that the Info
BW cannot meet the requirements of transmit mask BW.
3 Returns the RRC Correlated trace data as a list of x,y pairs.
The x-axis values are in units of second. The y-values are unified.
4 Returns the Transmit Mask trace data as a list of x,y pairs.
The x-axis values are in units of Hz. The y-values are in units of dB.
5 Returns the Spectrum trace data as a list of x,y pairs.
The x-axis values are in units of Hz. The y-values are in units of dB.
6 Returns the binary values of decoded bits.
7 Returns the following comma-separated scalar results:
1 Pass/Fail result of SYNC Status
2 Pass/Fail result of SFD Status
3 Pass/Fail result of PHR Status
4 Pass/Fail result of Payload Status
5 Pass/Fail result of STS Status
6 Data Rate (Mbps)
7 Preamble Duration(symbols)
8 Frame Length (octet)
9 Ranging
10 Reserved
11 Pass/Fail result of MAC FCS
12 A0
13 A1
14 SECDED Err Loc
15 SECDED Status
16 ERDEV-HPRF Frame Length (octet)
Items 12 (A0), 13 (A1) and 16 (ERDEV-HPRF Frame Length) are valid only if PHY Mode is ERDEV-HPRF.
Items 6 (Data Rate), 7 (Preamble Duration) and 11 (MAC FCS) are valid when PHY Mode is Non-ERDEV and
434 Short Range Comms & IoT Mode User's &Programmer's Reference
To Next Page
Loading...
Need help?
General
