Link Aggregation Commands
page 12-50 OmniSwitch 6250 CLI Reference Guide November 2009
A port that belongs to a static aggregate is specified:
-> show linkagg port 4/1
Static Aggregable Port
SNMP Id : 4001,
Slot/Port : 4/1,
Administrative State : ENABLED,
Operational State : DOWN,
Port State : CONFIGURED,
Link State : DOWN,
Selected Agg Number : 2,
Port position in the aggregate: 0,
Primary port : NONE
Output fields are defined here:
output definitions
SNMP Id The SNMP ID associated with this port.
Slot/Port The slot and port number.
Administrative State The current administrative state of this port, which can be ENABLED
or DISABLED.
Operational State The current operational state of the port, which can be UP or DOWN.
Port State The current operational state of the port, which can be
CONFIGURED, PENDING, SELECTED, or RESERVED.
Link State The current operational state of the link from this port to its remote
partner, which can be UP or DOWN.
Selected Agg Number The number associated with the static aggregate group to which the
port is attached.
Port position in the aggregate The rank of this port within the static aggregate group. Possible values
are 0–15.
Primary Port The port number of the first port to join this static aggregate group. If
the first port to join the aggregate is no longer part of the aggregate
group, the switch automatically assigns another port in the aggregate
group to be the primary port.
To Next Page
Loading...
