Link Aggregation Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 12-51
A port that belongs to a dynamic aggregate is specified:
-> show linkagg port 2/1
Dynamic Aggregable Port
SNMP Id : 2001,
Slot/Port : 2/1,
Administrative State : ENABLED,
Operational State : DOWN,
Port State : CONFIGURED,
Link State : DOWN,
Selected Agg Number : NONE,
Primary port : UNKNOWN,
LACP
Actor System Priority : 10,
Actor System Id : [00:d0:95:6a:78:3a],
Actor Admin Key : 8,
Actor Oper Key : 8,
Partner Admin System Priority : 20,
Partner Oper System Priority : 20,
Partner Admin System Id : [00:00:00:00:00:00],
Partner Oper System Id : [00:00:00:00:00:00],
Partner Admin Key : 8,
Partner Oper Key : 0,
Attached Agg Id : 0,
Actor Port : 7,
Actor Port Priority : 15,
Partner Admin Port : 0,
Partner Oper Port : 0,
Partner Admin Port Priority : 0,
Partner Oper Port Priority : 0,
Actor Admin State : act1.tim1.agg1.syn0.col0.dis0.def1.exp0
Actor Oper State : act1.tim1.agg1.syn0.col0.dis0.def1.exp0,
Partner Admin State : act0.tim0.agg1.syn1.col1.dis1.def1.exp0,
Partner Oper State : act0.tim0.agg1.syn0.col1.dis1.def1.exp0
Output fields are defined here:
output definitions
SNMP Id The SNMP ID associated with this port.
Slot/Port The slot and port number.
Administrative State The current administrative state of this port, which can be ENABLED
or DISABLED.
Operational State The current operational state of the port, which can be UP or DOWN.
Port State The current operational state of the port, which can be
CONFIGURED, PENDING, SELECTED, or AGGREGATED.
Link State The current operational state of the link from this port to its remote
partner, which can be UP or DOWN.
Selected Agg Number The number associated with the dynamic aggregate group to which the
port is attached.
Primary Port The port number of the first port to join this dynamic aggregate group.
If the first port to join the aggregate is no longer part of the aggregate
group, the switch automatically assigns another port in the aggregate
group to be the primary port.