Distributed Spanning Tree Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 16-143
Release History
Release 6.6.1; command was introduced.
Related Commands
Aut Edg The edge port automatic status: yes indicates that the port is an auto-
matic edge port; no indicates that the port is not an automatic edge port.
Configured through the bridge cist slot/port auto-edge or bridge 1x1
slot/port auto-edge command.
Rstr Tcn The restricted TCN capability: yes indicates that the port supports the
restricted TCN capability; no indicates that the port does not support
the restricted TCN capability. Configured through the bridge cist slot/
port restricted-tcn or bridge 1x1 slot/port restricted-tcn command.
Rstr Role The restricted role port status: yes indicates that the port is a restricted
role port; no indicates that the port is not a restricted role port. Config-
ured through the bridge cist slot/port restricted-role or bridge 1x1
slot/port restricted-role command.
OS8800 10G Opt. N/A
PVST+ Cfg Indicates the current PVST+ port configuration (auto, enable or dis-
able).
PVST+ Stat Indicates the current status of the PVST+ port (On or Off).
show spantree cist ports Implicit command for displaying Spanning Tree port information
for the flat mode CIST when the switch is operating in the 1x1 or
flat Spanning Tree mode.
show spantree msti ports Explicit command for displaying Spanning Tree port information
for an MSTI when the switch is operating in the 1x1 or flat Span-
ning Tree mode.
show spantree 1x1 ports Explicit command for displaying Spanning Tree port information
for a VLAN instance when the switch is operating in the 1x1 or flat
Spanning Tree mode.
output definitions (continued)
To Next Page
Loading...
