Distributed Spanning Tree Commands
page 16-142 OmniSwitch 6250 CLI Reference Guide November 2009
-> show spantree 2 ports configured
Spanning Tree Port Admin Configuration for Vlan 2
Port Adm Man. Config Adm Adm Aut Rstr Rstr OS8800 PVST+
Port Pri St. Mode Cost Cnx Edg Edg Tcn Role 10G Opt. Cfg Stst
-----+----+----+----+-------+----+----+----+----+----+---------+---------
3/1 7 ENA No 0 AUT No Yes No No DIS AUT/ON
3/3 7 ENA No 0 AUT No Yes No No DIS AUT/OFF
0/9 7 ENA No 0 AUT No Yes No No DIS AUT/ON
Desig Cost The path cost of the Designated Port of the segment connected to this
port. If this is the root bridge or the Spanning Tree status of the port is
administratively disabled, this value is 0.
Role The role of the port for this Spanning Tree instance. Possible port roles
are: root, designated, alternate, and backup.
Prim. Port The slot number for the module and the physical port number on that
module for the primary port associated with this Spanning Tree
instance. This information is only available if the port role is backup.
Op Cnx Operational connection type: PTP, NPT, or NS (nonsignificant).
Shows the current operational state of the port’s connection type. See
the bridge slot/port connection command on page 16-87 for more
information.
Op Edg Operational connection type: EDG. Shows the current operational state
of the port’s connection type. See the bridge slot/port connection
command on page 16-87 for more information.
Desig Bridge ID The bridge identifier for the designated bridge for this port’s segment.
output definitions
Port The slot number for the module and the physical port number or a logi-
cal port. If the slot number is 0, then the port number refers to a link
aggregate logical port number (e.g., 0/31).
Port Pri The Spanning Tree priority for the port (0–15). The lower the number,
the higher the priority. Configured through the bridge slot/port prior-
ity command.
Adm St The Spanning Tree administrative status of the port: enabled or dis-
abled. Configured through the bridge slot/port command to enable or
disable Spanning Tree on a port.
Man. Mode The manual mode setting for the port: yes indicates that the blocking or
forwarding state of the port was manually set and the port does not par-
ticipate in the Spanning Tree Algorithm; no indicates that the Spanning
Tree Algorithm is managing the port state. Configured through the
bridge slot/port mode command.
Config Cost The configured path cost value for this port. Configured through the
bridge slot/port path cost command.
Adm Cnx The administrative connection type: PTP, NPT, or AUT. Configured
through the bridge slot/port connection command.
Adm Edg The edge port administrative status: yes indicates that the port is an
admin edge port; no indicates that the port is not an admin edge port.
Configured through the bridge slot/port connection
command.
output definitions (continued)
To Next Page
Loading...
