Keysight x-series Instruction Manual

3 Short-Range Comms & IoT Mode
3.5 Channel Power Measurement
For full details, see "Parameter Options, Installed Options & Ranges" on page 640
below.
Remote Command
[:SENSe]:CHPower:FREQuency:SYNThesis[:STATe] 1 | … | 5
For the meaning of each numeric option value, see "Parameter Options, Installed Options & Ranges"
on page 640 below
[:SENSe]:CHPower:FREQuency:SYNThesis[:STATe]?
Example
:CHP:FREQ:SYNT 1
:CHP:FREQ:SYNT?
Dependencies Does not appear in all models. For models in which the control is not displayed, the SCPI command is
accepted for compatibility, although no action is taken
Preset 3
State Saved Saved in instrument state
Range See "Ranges" on page 645 below
Auto Function
Remote
Command
[:SENSe]:CHPower:FREQuency:SYNThesis:AUTO[:STATe] OFF | ON | 0 | 1
[:SENSe]:CHPower:FREQuency:SYNThesis:AUTO[:STATe]?
Example
:CHP:FREQ:SYNT:AUTO 1
:CHP:FREQ:SYNT:AUTO?
Preset
OFF
Parameter Options, Installed Options & Ranges
The Phase Noise Optimization control lets you optimize the setup and behavior of
the Local Oscillator (LO) depending on your specific measurement conditions. You
may wish to trade off noise and speed, for example, to make a measurement faster
without regard to noise or with optimum noise characteristics without regard to
speed.
Parameter Values Summary
Option # Description
"Balanced" on
page 641
1
–
In instruments with EP0, balances close-in phase noise with spur
avoidance
–
In instruments without EP0 optimizes phase noise for small
frequency offsets from the carrier
"Best Wide-
offset" on page
642
2 Optimizes phase noise for wide frequency offsets from the carrier
"Fast Tuning"
on page 642
3 Optimizes LO for tuning speed
640 Short Range Comms & IoT Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)