Distributed Spanning Tree Commands
page 16-140 OmniSwitch 6250 CLI Reference Guide November 2009
0 1/22 DIS 0 DIS
0 1/23 DIS 0 DIS
0 1/24 DIS 0 DIS
0 5/1 DIS 0 DIS
0 5/2 DIS 0 DIS
1 1/1 FORW 200000 MSTR
1 1/2 DIS 0 DIS
1 1/3 DIS 0 DIS
1 1/4 DIS 0 DIS
1 1/5 DIS 0 DIS
1 1/6 DIS 0 DIS
1 1/7 DIS 0 DIS
1 1/8 DIS 0 DIS
1 1/9 DIS 0 DIS
1 1/10 DIS 0 DIS
1 1/11 DIS 0 DIS
1 1/12 DIS 0 DIS
1 1/13 DIS 0 DIS
1 1/14 DIS 0 DIS
1 1/15 DIS 0 DIS
1 1/16 DIS 0 DIS
1 1/17 DIS 0 DIS
1 1/18 DIS 0 DIS
1 1/19 DIS 0 DIS
1 1/20 DIS 0 DIS
1 1/21 DIS 0 DIS
1 1/22 DIS 0 DIS
1 1/23 DIS 0 DIS
1 1/24 DIS 0 DIS
-> show spantree ports active
Msti Port Oper Status Path Cost Role
-----+-----+------------+---------+-----
0 1/1 FORW 200000 ROOT
1 1/1 FORW 200000 MSTR
2 1/1 FORW 200000 MSTR
output definitions
Msti The Multiple Spanning Tree Instance (MSTI) instance number. Config-
ured through the bridge msti command. Note that MSTI 0 also repre-
sents the CIST instance that is always present on the switch.
Port The slot number for the module and the physical port number or a logi-
cal port. If the slot number is 0, then the port number refers to a link
aggregate logical port number (e.g., 0/31).
Oper St The port operational state as defined by application of the Spanning
Tree Protocol. Possible port operational states include: disabled, block-
ing, learning, and forwarding.
Path Cost The contribution of this port to the path cost towards the Spanning Tree
root bridge that includes this port. Path cost is a measure of the distance
of the listed port from the root bridge in the number of hops. Config-
ured through the bridge slot/port path cost command.
Role The role of the port for this Spanning Tree instance. Possible port roles
are: root, designated, alternate, and backup.
To Next Page
Loading...
