Keysight Technologies InfiniiVision 4000 X Series

1008 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
31 :SBUS<n> Commands
:SBUS<n>:MANChester:LOGic
(see page 1610)
Command Syntax
:SBUS<n>:MANChester:LOGic <logic>
<logic> ::= {FALLing | RISing}
The :SBUS<n>:MANChester:LOGic command specifies the polarity of the
Manchester signal:
• FALLing — specifies that a falling edge is used to encode a bit value of logic 1
(and a rising edge encodes a bit value of logic 0).
• RISing — specifies that a rising edge is used to encode a bit value of logic 1.
Query Syntax
:SBUS<n>:MANChester:LOGic?
The :SBUS<n>:MANChester:LOGic? query returns the polarity setting.
Return Format
<logic><NL>
<logic> ::= {FALL | RIS}
See Also • ":SBUS<n>:MANChester:BASE" on page 1001
• ":SBUS<n>:MANChester:BITorder" on page 1003
• ":SBUS<n>:MANChester:IDLE:BITS" on page 1007
• ":SBUS<n>:MANChester:STARt" on page 1011