1080 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
31 :SBUS<n> Commands
:SBUS<n>:SPI:SOURce:CLOCk
(see page 1610)
Command Syntax
:SBUS<n>:SPI:SOURce:CLOCk <source>
<source> ::= {CHANnel<n> | EXTernal} for the DSO models
<source> ::= {CHANnel<n> | DIGital<d>} for the MSO models
<n> ::= 1 to (# analog channels) in NR1 format
<d> ::= 0 to (# digital channels - 1) in NR1 format
The :SBUS<n>:SPI:SOURce:CLOCk command sets the source for the SPI serial
clock.
Query Syntax
:SBUS<n>:SPI:SOURce:CLOCk?
The :SBUS<n>:SPI:SOURce:CLOCk? query returns the current source for the SPI
serial clock.
Return Format
<source><NL>
See Also • "Introduction to :TRIGger Commands" on page 1295
• ":SBUS<n>:SPI:CLOCk:SLOPe" on page 1076
• ":SBUS<n>:SPI:CLOCk:TIMeout" on page 1077
• ":SBUS<n>:SPI:SOURce:FRAMe" on page 1081
• ":SBUS<n>:SPI:SOURce:MOSI" on page 1083
• ":SBUS<n>:SPI:SOURce:MISO" on page 1082
To Next Page
Loading...
