EasyManua.ls Logo

Keysight Technologies InfiniiVision 4000 X Series

Keysight Technologies InfiniiVision 4000 X Series
1762 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
772 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
28 :POWer Commands
:POWer:PSRR:WGEN:VOLTage
(see page 1610)
Command Syntax
:POWer:PSRR:WGEN:VOLTage <amplitude>[,<range>]
<amplitude> ::= amplitude in volts in NR3 format
<range> ::= {F20HZ | F100HZ | F1KHZ | F10KHZ | F100KHZ | F1MHZ
| F10MHZ | F20MHZ}
The :POWer:PSRR:WGEN:VOLTage command sets the waveform generator output
amplitude(s).
When the waveform generator amplitude profile is enabled (with the
:POWer:PSRR:WGEN:VOLTage:PROFile command), you can set an initial ramp
amplitude for each frequency range.
Without the <range> parameter, this command sets the waveform generator
output amplitude used when the amplitude profile is disabled.
Query Syntax
:POWer:PSRR:WGEN:VOLTage? [<range>]
The :POWer:PSRR:WGEN:VOLTage? query returns the waveform generator output
amplitude setting(s).
Return Format
<amplitude><NL>
<amplitude> ::= amplitude in volts in NR3 format
See Also ":POWer:PSRR" on page 760
":POWer:PSRR:APPLy" on page 761
":POWer:PSRR:DATA" on page 762
":POWer:PSRR:FREQuency:MAXimum" on page 763
":POWer:PSRR:FREQuency:MINimum" on page 764
":POWer:PSRR:FREQuency:MODE" on page 765
":POWer:PSRR:PPDecade" on page 767
":POWer:PSRR:SOURce:INPut" on page 768
":POWer:PSRR:SOURce:OUTPut" on page 769
":POWer:PSRR:WGEN:LOAD" on page 771
":POWer:PSRR:WGEN:VOLTage:PROFile" on page 773

Table of Contents

Related product manuals