1424 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
36 :WAVeform Commands
:WAVeform:VIEW
(see page 1610)
Command Syntax
:WAVeform:VIEW <view>
<view> ::= {MAIN | ALL}
The :WAVeform:VIEW command sets the view setting associated with the currently
selected waveform:
• MAIN — This view specifies the data you see in the oscilloscope's main
waveform display area.
• ALL — Available only when Digitizer mode is on (see :ACQuire:DIGitizer), this
view specifies all the captured data, which may extend beyound the edges of
the oscilloscope's main waveform display area depending on the settings for
sample rate, memory depth, and horizontal time/div.
Query Syntax
:WAVeform:VIEW?
The :WAVeform:VIEW? query returns the view setting associated with the currently
selected waveform.
Return Format
<view><NL>
<view> ::= {MAIN | ALL}
See Also • "Introduction to :WAVeform Commands" on page 1396
• ":WAVeform:POINts" on page 1406
• ":ACQuire:DIGitizer" on page 306