EasyManua.ls Logo

Keysight Technologies InfiniiVision 4000 X Series

Keysight Technologies InfiniiVision 4000 X Series
1762 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
934 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
31 :SBUS<n> Commands
:SBUS<n>:FLEXray:TRIGger
(see page 1610)
Command Syntax
:SBUS<n>:FLEXray:TRIGger <condition>
<condition> ::= {FRAMe | ERRor | EVENt}
The :SBUS<n>:FLEXray:TRIGger:TRIGger command sets the FLEXray trigger on
condition:
FRAMe — triggers on specified frames (without errors).
ERRor — triggers on selected active error frames and unknown bus conditions.
EVENt — triggers on specified FlexRay event/symbol.
Query Syntax
:SBUS<n>:FLEXray:TRIGger?
The :SBUS<n>:FLEXray:TRIGger? query returns the current FLEXray trigger on
condition.
Return Format
<condition><NL>
<condition> ::= {FRAM | ERR | EVEN}
See Also "Introduction to :TRIGger Commands" on page 1295
":TRIGger:MODE" on page 1308
":SBUS<n>:FLEXray:TRIGger:ERRor:TYPE" on page 935
":SBUS<n>:FLEXray:TRIGger:EVENt:AUToset" on page 936
":SBUS<n>:FLEXray:TRIGger:EVENt:BSS:ID" on page 937
":SBUS<n>:FLEXray:TRIGger:EVENt:TYPE" on page 938
":SBUS<n>:FLEXray:TRIGger:FRAMe:CCBase" on page 939
":SBUS<n>:FLEXray:TRIGger:FRAMe:CCRepetition" on page 940
":SBUS<n>:FLEXray:TRIGger:FRAMe:ID" on page 941
":SBUS<n>:FLEXray:TRIGger:FRAMe:TYPE" on page 942

Table of Contents

Related product manuals