To Next Page

To Previous Page

:MEASure Commands 24

Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 587

:MEASure:DUAL:VPP

(see page 1610)

Overview This measurement is available with the N2820A high sensitivity current probe

when both the Primary and Secondary probe cables are used. This measurement

joins the Zoom In waveform data below the probe's clamp level with Zoom Out

waveform data above the probe's clamp level to create the waveform on which the

measurement is made.

Command Syntax

:MEASure:DUAL:VPP [<source1>][,<source2>]

<source1>,<source2> ::= CHANnel<n> with N2820A probe connected

<n> ::= 1 to (# analog channels) in NR1 format

The :MEASure:DUAL:VPP command installs a screen measurement and starts a

vertical peak-to-peak measurement.

If the optional source parameter(s) are specified, the currently specified source(s)

are modified.

Query Syntax

:MEASure:DUAL:VPP? [<source1>][,<source2>]

The :MEASure:DUAL:VPP? query measures the maximum and minimum vertical

value for the selected source, then calculates the vertical peak-to-peak value and

returns that value. The peak-to-peak value (Vpp) is calculated with the following

formula:

Vpp = Vmax - Vmin

Vmax and Vmin are the vertical maximum and minimum values present on the

selected source.

Return Format

<value> ::= vertical peak to peak value in NR3 format

See Also • ":MEASure:DUAL:CHARge" on page 583

• ":MEASure:DUAL:VAMPlitude" on page 584

• ":MEASure:DUAL:VAVerage" on page 585

• ":MEASure:DUAL:VBASe" on page 586

• ":MEASure:DUAL:VRMS" on page 588

• "Introduction to :MEASure Commands" on page 568

• ":MEASure:SOURce" on page 615

• ":MEASure:VMAX" on page 631

• ":MEASure:VMIN" on page 632

Keysight Technologies InfiniiVision 4000 X Series User Manual

Questions and Answers: