Keysight Technologies InfiniiVision 4000 X Series User Manual

:WGEN<w> Commands 37
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1467
:WGEN<w>:OUTPut:MODE
(see page 1610)
Command Syntax
:WGEN<w>:OUTPut:MODE <mode>
<mode> ::= {NORMal | SINGle}
The :WGEN<w>:OUTPut:MODE command specifies whether the defined waveform
is output continuously or as a single cycle (single-shot):
• NORMal — the defined waveform is output continuously.
• SINGle — one cycle of the defined waveform is output when you send the
:WGEN<w>:OUTPut:SINGle command.
Not all waveform types allow single-shot output.
Query Syntax
:WGEN<w>:OUTPut:MODE?
The :WGEN<w>:OUTPut:MODE? query returns the output mode setting.
Return Format
<mode><NL>
<mode> ::= {NORMal | SINGle}
See Also • ":WGEN<w>:OUTPut:SINGle" on page 1469

Keysight Technologies InfiniiVision 4000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 4000 X Series
Category	Test Equipment
Language	English