1028 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
31 :SBUS<n> Commands
:SBUS<n>:NRZ:IDLE:STATe
(see page 1610)
Command Syntax
:SBUS<n>:NRZ:IDLE:STATe <state>
<state> ::= {LOW | HIGH}
The :SBUS<n>:NRZ:IDLE:STATe command specifies the idle state of the NRZ
signal.
Query Syntax
:SBUS<n>:NRZ:IDLE:STATe?
The :SBUS<n>:NRZ:IDLE:STATe? query returns the idle state setting.
Return Format
<state><NL>
<state> ::= {LOW | HIGH}
See Also • ":SBUS<n>:NRZ:BASE" on page 1020
• ":SBUS<n>:NRZ:BITorder" on page 1022
• ":SBUS<n>:NRZ:IDLE:BITS" on page 1027
• ":SBUS<n>:NRZ:LOGic" on page 1029
To Next Page
Loading...
