804 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
28 :POWer Commands
:POWer:TRANsient:EXIT
(see page 1610)
Command Syntax
:POWer:TRANsient:EXIT
The :POWer:TRANsient:EXIT command exits (stops) the transient analysis.
This command is equivalent to pressing the Exit softkey on the oscilloscope front
panel during the analysis.
See Also • ":POWer:TRANsient:APPLy" on page 803
• ":POWer:TRANsient:IINitial" on page 805
• ":POWer:TRANsient:INEW" on page 806
• ":POWer:TRANsient:NEXT" on page 807
To Next Page
Loading...
