EasyManua.ls Logo

Keysight Technologies InfiniiVision 4000 X Series

Keysight Technologies InfiniiVision 4000 X Series
1762 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
444 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
19 :FRANalysis Commands
:FRANalysis:FREQuency:SINGle
(see page 1610)
Command Syntax
:FRANalysis:FREQuency:SINGle <value>[suffix]
<value> ::= {20 | 100 | 1000 | 10000 | 100000 | 1000000 | 10000000
| 2000000}
[suffix] ::= {Hz | kHz| MHz}
The :FRANalysis:FREQuency:SINGle command command sets the single frequency
value. The frequency response analysis is displayed on a log scale Bode plot, so
you can select from decade values in addition to the minimum frequency of 20 Hz.
Query Syntax
:FRANalysis:FREQuency:SINGle?
The :FRANalysis:FREQuency:SINGle? query returns the single frequency setting.
Return Format
<value><NL>
<value> ::= {20 | 100 | 1000 | 10000 | 100000 | 1000000 | 10000000
| 2000000}
See Also ":FRANalysis:DATA" on page 441
":FRANalysis:ENABle" on page 442
":FRANalysis:PPDecade" on page 447
":FRANalysis:FREQuency:MODE" on page 443
":FRANalysis:RUN" on page 448
":FRANalysis:SOURce:INPut" on page 449
":FRANalysis:SOURce:OUTPut" on page 450
":FRANalysis:WGEN:LOAD" on page 452
":FRANalysis:WGEN:VOLTage" on page 453
":FRANalysis:WGEN:VOLTage:PROFile" on page 454

Table of Contents

Related product manuals