:WGEN<w> Commands 37
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1475
:WGEN<w>:TRACk:FREQuency
(see page 1610)
Command Syntax
:WGEN<w>:TRACk:FREQuency <on_off>
<w> ::= 1 to (# WaveGen outputs) in NR1 format
<on_off> ::= {{1 | ON} | {0 | OFF}
The :WGEN<w>:TRACk:FREQuency ON command causes frequency adjustments
to this waveform generator output signal to be tracked by the other waveform
generator output.
Not all waveform shapes can be frequency tracked. When :WGEN<w>:TRACk or
:WGEN<w>:TRACk:FREQuency is enabled, the other generator's waveform
selections (:WGEN<w>:FUNCtion) must be in the same group as this generator's
waveform:
When tracking is enabled, adjustments for tracked settings in the other waveform
generator become unavailable.
Query Syntax
:WGEN<w>:TRACk:FREQuency?
The :WGEN<w>:TRACk:FREQuency? query returns whether frequency tracking is
on or off.
Return Format
<on_off><NL>
<on_off> ::= {1 | 0}
See Also • ":WGEN<w>:TRACk:PHASe" on page 1476
• ":WGEN<w>:FUNCtion" on page 1446
• ":WGEN<w>:TRACk" on page 1472
• ":WGEN<w>:TRACk:AMPLitude" on page 1473
• ":WGEN<w>:TRACk:CSIGnal" on page 1474
Group 1 Group 2 Group 3 Group 4
SINusoid
RAMP
SINC
CARDiac
GAUSsian
SQUare
PULSe
EXPRise
EXPFall
ARBitrary