Keysight Technologies InfiniiVision 4000 X Series User Manual

:POWer Commands 28
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 727
:POWer:CLResponse:TRACe
(see page 1610)
Command Syntax
:POWer:CLResponse:TRACe <selection>
<selection> ::= {NONE | ALL | GAIN | PHASe}[,{GAIN | PHASe}]
The :POWer:CLResponse:TRACe command specifies whether to include gain,
phase, both gain and phase, or neither in the control loop response analysis
results.
Query Syntax
:POWer:CLResponse:TRACe?
The :POWer:CLResponse:TRACe? query returns a comma-separated list of the
types of data that are currently included in the control loop response analysis
results, or "NONE" if neither gain nor phase data is included.
Return Format
<selection_list><NL>
<selection_list> ::= {"NONE" | "GAIN" | "PHASe" | "GAIN,PHASe"}
See Also • ":POWer:CLResponse:APPLy" on page 714
• ":POWer:CLResponse:DATA" on page 715
NOTE
This command affects the oscilloscope's front panel graphical user interface (plot and table)
as well as when saving analysis data.

Keysight Technologies InfiniiVision 4000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 4000 X Series
Category	Test Equipment
Language	English