To Next Page

To Previous Page

776 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide

28 :POWer Commands

:POWer:SIGNals:AUTosetup

(see page 1610)

Command Syntax

:POWer:SIGNals:AUTosetup <analysis>

<analysis> ::= {HARMonics | EFFiciency | RIPPle | MODulation | QUALity

| SLEW | SWITch | RDSVce}

The :POWer:SIGNals:AUTosetup command performs automated oscilloscope

setup for the signals in the specified type of power analysis.

See Also • ":POWer:HARMonics:DISPlay" on page 737

• ":POWer:EFFiciency:APPLy" on page 732

• ":POWer:RIPPle:APPLy" on page 775

• ":POWer:MODulation:APPLy" on page 751

• ":POWer:QUALity:APPLy" on page 774

• ":POWer:SLEW:APPLy" on page 795

• ":POWer:SWITch:APPLy" on page 797

• ":POWer:SIGNals:CYCLes:HARMonics" on page 777

• ":POWer:SIGNals:CYCLes:QUALity" on page 778

• ":POWer:SIGNals:DURation:EFFiciency" on page 779

• ":POWer:SIGNals:DURation:MODulation" on page 780

• ":POWer:SIGNals:DURation:RIPPle" on page 783

• ":POWer:SIGNals:IEXPected" on page 785

• ":POWer:SIGNals:OVERshoot" on page 786

• ":POWer:SIGNals:SOURce:CURRent<i>" on page 793

• ":POWer:SIGNals:SOURce:VOLTage<i>" on page 794

Keysight Technologies InfiniiVision 4000 X Series User Manual

Questions and Answers: