:SBUS<n> Commands 31
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1097
:SBUS<n>:UART:COUNt:RESet
(see page 1610)
Command Syntax
:SBUS<n>:UART:COUNt:RESet
Resets the UART frame counters.
Errors • "-241, Hardware missing" on page 1551
See Also • ":SBUS<n>:UART:COUNt:ERRor" on page 1096
• ":SBUS<n>:UART:COUNt:RXFRames" on page 1098
• ":SBUS<n>:UART:COUNt:TXFRames" on page 1099
• "Introduction to :SBUS<n> Commands" on page 853
• ":SBUS<n>:MODE" on page 857
• ":SBUS<n>:UART Commands" on page 1090
To Next Page
Loading...
