Keysight Technologies InfiniiVision 4000 X Series

853
Keysight InfiniiVision 4000 X-Series Oscilloscopes
Programmer's Guide
31 :SBUS<n> Commands
Control the modes and parameters for each serial bus decode/trigger type. See:
• "Introduction to :SBUS<n> Commands" on page 853
• "General :SBUS<n> Commands" on page 855
• ":SBUS<n>:A429 Commands" on page 858
• ":SBUS<n>:CAN Commands" on page 877
• ":SBUS<n>:CXPI Commands" on page 907
• ":SBUS<n>:FLEXray Commands" on page 924
• ":SBUS<n>:I2S Commands" on page 943
• ":SBUS<n>:IIC Commands" on page 962
• ":SBUS<n>:LIN Commands" on page 973
• ":SBUS<n>:M1553 Commands" on page 992
• ":SBUS<n>:MANChester Commands" on page 999
• ":SBUS<n>:NRZ Commands" on page 1018
• ":SBUS<n>:SENT Commands" on page 1037
• ":SBUS<n>:SPI Commands" on page 1073
• ":SBUS<n>:UART Commands" on page 1090
• ":SBUS<n>:USB Commands" on page 1112
• ":SBUS<n>:USBPd Commands" on page 1137
Introduction to
:SBUS<n>
Commands
The :SBUS subsystem commands control the serial decode bus viewing, mode,
and other options.
The following serial bus decode/trigger types are available (see ":TRIGger:MODE"
on page 1308).
NOTE
These commands are only valid on oscilloscope models when a serial decode option has been
licensed.