:DISPlay Commands 16
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 417
:DISPlay:INTensity:WAVeform
(see page 1610)
Command Syntax
:DISPlay:INTensity:WAVeform <value>
<value> ::= an integer from 0 to 100 in NR1 format.
The :DISPlay:INTensity:WAVeform command sets the waveform intensity.
This is the same as adjusting the front panel [Intensity] knob.
Query Syntax
:DISPlay:INTensity:WAVeform?
The :DISPlay:INTensity:WAVeform? query returns the waveform intensity setting.
Return Format
<value><NL>
<value> ::= an integer from 0 to 100 in NR1 format.
See Also • "Introduction to :DISPlay Commands" on page 403
To Next Page
Loading...
