To Next Page

To Previous Page

:FRANalysis Commands 19

Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 445

:FRANalysis:FREQuency:STARt

(see page 1610)

Command Syntax

:FRANalysis:FREQuency:STARt <value>[suffix]

<value> ::= {20 | 100 | 1000 | 10000 | 100000 | 1000000 | 10000000}

[suffix] ::= {Hz | kHz| MHz}

The :FRANalysis:FREQuency:STARt command command sets the frequency sweep

start value. The frequency response analysis is displayed on a log scale Bode plot,

so you can select from decade values in addition to the minimum frequency of

20 Hz.

Query Syntax

:FRANalysis:FREQuency:STARt?

The :FRANalysis:FREQuency:STARt? query returns the frequency sweep start

setting.

Return Format

<value> ::= {20 | 100 | 1000 | 10000 | 100000 | 1000000 | 10000000}

See Also • ":FRANalysis:DATA" on page 441

• ":FRANalysis:ENABle" on page 442

• ":FRANalysis:FREQuency:STOP" on page 446

• ":FRANalysis:PPDecade" on page 447

• ":FRANalysis:FREQuency:MODE" on page 443

• ":FRANalysis:RUN" on page 448

• ":FRANalysis:SOURce:INPut" on page 449

• ":FRANalysis:SOURce:OUTPut" on page 450

• ":FRANalysis:WGEN:LOAD" on page 452

• ":FRANalysis:WGEN:VOLTage" on page 453

• ":FRANalysis:WGEN:VOLTage:PROFile" on page 454

Keysight Technologies InfiniiVision 4000 X Series User Manual

Questions and Answers: