756 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
28 :POWer Commands
:POWer:ONOFf:NEXT
(see page 1610)
Command Syntax
:POWer:ONOFf:NEXT
The :POWer:ONOFf:NEXT command goes to the next step of the turn on/turn off
analysis.
This command is equivalent to pressing the Next softkey on the oscilloscope front
panel when prompted during the analysis.
See Also • ":POWer:ONOFf:THResholds" on page 758
• ":POWer:ITYPe" on page 750
• ":POWer:ONOFf:APPLy" on page 754
• ":POWer:ONOFf:EXIT" on page 755
• ":POWer:ONOFf:TEST" on page 757
To Next Page
Loading...
