Keysight Technologies InfiniiVision 4000 X Series

450 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
19 :FRANalysis Commands
:FRANalysis:SOURce:OUTPut
(see page 1610)
Command Syntax
:FRANalysis:SOURce:OUTPut <source>
<source> ::= CHANnel<n>
<n> ::= 1 to (# analog channels) in NR1 format
The :FRANalysis:SOURce:OUTPut command specifies the analog input channel
that is probing the output voltage from the device under test (DUT) in the
frequency response analysis.
Query Syntax
:FRANalysis:SOURce:OUTPut?
The :FRANalysis:SOURce:OUTPut? query returns the currently selected channel
probing the output voltage.
Return Format
<source><NL>
<source> ::= CHAN<n>
See Also • ":FRANalysis:DATA" on page 441
• ":FRANalysis:ENABle" on page 442
• ":FRANalysis:FREQuency:STARt" on page 445
• ":FRANalysis:FREQuency:STOP" on page 446
• ":FRANalysis:RUN" on page 448
• ":FRANalysis:SOURce:INPut" on page 449
• ":FRANalysis:WGEN:LOAD" on page 452
• ":FRANalysis:WGEN:VOLTage" on page 453