Keysight Technologies InfiniiVision 4000 X Series User Manual

:POWer Commands 28
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 717
:POWer:CLResponse:DATA:GMARgin:FREQuency
(see page 1610)
Query Syntax
:POWer:CLResponse:DATA:GMARgin:FREQuency?
After the Control Loop Response (Bode) power analysis has been performed (see
:POWer:CLResponse:APPLy), the
:POWer:CLResponse:DATA:GMARgin:FREQuency? query returns the 0° phase
crossover frequency in Hz.
Return Format
<frequency><NL>
<frequency> ::= 0 degrees phase crossover frequency in Hz in NR3 format
The query returns +9.9E+37 if the value cannot be calculated from the last sweep
(that is, if there are no crossover points).
See Also • ":POWer:CLResponse:APPLy" on page 714
• ":POWer:CLResponse:DATA" on page 715
• ":POWer:CLResponse:DATA:GMARgin" on page 716
• ":POWer:CLResponse:DATA:PMARgin" on page 718
• ":POWer:CLResponse:DATA:PMARgin:FREQuency" on page 719

Keysight Technologies InfiniiVision 4000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 4000 X Series
Category	Test Equipment
Language	English