Keysight Technologies InfiniiVision 4000 X Series User Manual

:FRANalysis Commands 19
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 451
:FRANalysis:TRACe
(see page 1610)
Command Syntax
:FRANalysis:TRACe <selection>
<selection> ::= {NONE | ALL | GAIN | PHASe}[,{GAIN | PHASe}]
The :FRANalysis:TRACe command specifies whether to include gain, phase, both
gain and phase, or neither in the frequency response analysis results.
Query Syntax
:FRANalysis:TRACe?
The :FRANalysis:TRACe? query returns a comma-separated list of the types of
data that are currently included in the frequency response analysis results, or
"NONE" if neither gain nor phase data is included.
Return Format
<selection_list><NL>
<selection_list> ::= {"NONE" | "GAIN" | "PHASe" | "GAIN,PHASe"}
See Also • ":FRANalysis:RUN" on page 448
• ":FRANalysis:DATA" on page 441
NOTE
This command affects the oscilloscope's front panel graphical user interface (plot and table)
as well as when saving analysis data.

Keysight Technologies InfiniiVision 4000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 4000 X Series
Category	Test Equipment
Language	English