Keysight Technologies InfiniiVision 4000 X Series User Manual

:WGEN<w> Commands 37
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1465
:WGEN<w>:OUTPut
(see page 1610)
Command Syntax
:WGEN<w>:OUTPut <on_off>
<w> ::= 1 to (# WaveGen outputs) in NR1 format
<on_off> ::= {{1 | ON} | {0 | OFF}
The :WGEN<w>:OUTPut command specifies whether the waveform generator
signal output is ON (1) or OFF (0).
Query Syntax
:WGEN<w>:OUTPut?
The :WGEN<w>:OUTPut? query returns the current state of the waveform
generator output setting.
Return Format
<on_off><NL>
<on_off> ::= {1 | 0}
See Also • "Introduction to :WGEN<w> Commands" on page 1435

Keysight Technologies InfiniiVision 4000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 4000 X Series
Category	Test Equipment
Language	English