To Next Page

To Previous Page

:WGEN<w> Commands 37

Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1477

:WGEN<w>:VOLTage

(see page 1610)

Command Syntax

:WGEN<w>:VOLTage <amplitude>

<w> ::= 1 to (# WaveGen outputs) in NR1 format

<amplitude> ::= amplitude in volts in NR3 format

For all waveforms except DC, the :WGEN<w>:VOLTage command specifies the

waveform's amplitude. Use the :WGEN<w>:VOLTage:OFFSet command to specify

the offset voltage or DC level.

You can also specify the amplitude and offset indirectly using the

:WGEN<w>:VOLTage:HIGH and :WGEN<w>:VOLTage:LOW commands. For

example, an amplitude of 5 V and an offset of 1 V is the same as a high-level

voltage of 4 V and a low-level voltage of -1 V.

Query Syntax

:WGEN<w>:VOLTage?

The :WGEN<w>:VOLTage? query returns the currently specified waveform

amplitude.

Return Format

<amplitude> ::= amplitude in volts in NR3 format

See Also • "Introduction to :WGEN<w> Commands" on page 1435

• ":WGEN<w>:FUNCtion" on page 1446

• ":WGEN<w>:VOLTage:OFFSet" on page 1480

• ":WGEN<w>:VOLTage:HIGH" on page 1478

• ":WGEN<w>:VOLTage:LOW" on page 1479

NOTE

When the amplitude is below 40 mV, the offset is limited to ±500 mV.

Keysight Technologies InfiniiVision 4000 X Series User Manual

Questions and Answers: