To Next Page

To Previous Page

:POD Commands 27

Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 701

:POD<n>:DISPlay

(see page 1610)

Command Syntax

:POD<n>:DISPlay <display>

<display> ::= {{1 | ON} | {0 | OFF}}

<n> ::= An integer, 1 or 2, is attached as a suffix to the command and

defines the group of channels that are affected by the command.

POD1 ::= D0-D7

POD2 ::= D8-D15

The :POD<n>:DISPlay command turns displaying of the specified group of

channels on or off.

Query Syntax

:POD<n>:DISPlay?

The :POD<n>:DISPlay? query returns the current display setting of the specified

group of channels.

Return Format

<display> ::= {0 | 1}

See Also • "Introduction to :POD<n> Commands" on page 699

• ":DIGital<d>:DISPlay" on page 395

• ":CHANnel<n>:DISPlay" on page 349

• ":VIEW" on page 297

• ":BLANk" on page 266

• ":STATus" on page 294

NOTE

This command is only valid for the MSO models.

Keysight Technologies InfiniiVision 4000 X Series User Manual

Questions and Answers: