Keysight Technologies InfiniiVision 4000 X Series

:SBUS<n> Commands 31
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1069
:SBUS<n>:SENT:TRIGger:SLOW:ID
(see page 1610)
Command Syntax
:SBUS<n>:SENT:TRIGger:SLOW:ID <id>
<id> ::= when ILENgth = SHORt, from -1 (don't care) to 15, in NR1 format
.
<id> ::= when ILENgth = LONG, from -1 (don't care) to 255, in NR1 format
.
The :SBUS<n>:SENT:TRIGger:SLOW:ID command specifies the ID to trigger on for
the "Slow Channel Message ID" and "Slow Channel Message ID & Data" trigger
modes. The ID can be from -1 (don't care) to 255 (depending on the message
length).
Query Syntax
:SBUS<n>:SENT:TRIGger:SLOW:ID?
The :SBUS<n>:SENT:TRIGger:SLOW:ID? query returns the slow channel ID setting.
Return Format
<id><NL>
<id> ::= when ILENgth = SHORt, from -1 (don't care) to 15, in NR1 format
.
<id> ::= when ILENgth = LONG, from -1 (don't care) to 255, in NR1 format
.
See Also • ":SBUS<n>:SENT:CLOCk" on page 1040
• ":SBUS<n>:SENT:CRC" on page 1041
• ":SBUS<n>:SENT:DISPlay" on page 1042
• ":SBUS<n>:SENT:FORMat" on page 1044
• ":SBUS<n>:SENT:IDLE" on page 1046
• ":SBUS<n>:SENT:LENGth" on page 1047
• ":SBUS<n>:SENT:PPULse" on page 1048
• ":SBUS<n>:SENT:SIGNal<s>:DISPlay" on page 1050
• ":SBUS<n>:SENT:SIGNal<s>:LENGth" on page 1051
• ":SBUS<n>:SENT:SIGNal<s>:MULTiplier" on page 1053
• ":SBUS<n>:SENT:SIGNal<s>:OFFSet" on page 1055
• ":SBUS<n>:SENT:SIGNal<s>:ORDer" on page 1057
• ":SBUS<n>:SENT:SIGNal<s>:STARt" on page 1059
• ":SBUS<n>:SENT:SOURce" on page 1061
• ":SBUS<n>:SENT:TOLerance" on page 1063
• ":SBUS<n>:SENT:TRIGger" on page 1064
• ":SBUS<n>:SENT:TRIGger:FAST:DATA" on page 1066