:POWer Commands 28
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 803
:POWer:TRANsient:APPLy
(see page 1610)
Command Syntax
:POWer:TRANsient:APPLy
The :POWer:TRANsient:APPLy command applies the transient analysis using the
initial current and new current settings.
See Also • ":POWer:TRANsient:EXIT" on page 804
• ":POWer:TRANsient:IINitial" on page 805
• ":POWer:TRANsient:INEW" on page 806
• ":POWer:TRANsient:NEXT" on page 807
• ":MEASure:TRESponse" on page 663
To Next Page
Loading...
